Replacement Parts

Each tap unit is sized to match or exceed the rpm and torque requirments specified by the customer. Please use the product selector to determine the best match unit for replacement parts. Or contact the factory for replacement parts. When contacting the factory, please provide the unit part number and serial number.

Recommended Spare Parts

At least one spare limit switch (part number J-282) should be kept on hand for replacement in an emergency. When replacing a limit switch, transfer one wire at a time from the old to the new switch, to avoid the possibility of getting the new switch wired incorrectly.

In high production applications an extra lead screw should also be kept on hand.

Locating Unit Serial Number

The unit serial number is located on the right side of the unit when looking at the spindle end. Be aware that the covers between units are interchangeable. Therefore, the part number on the cover may not be the correct part number of the unit. Consult the factory for determining the exact part number of your unit or locating the serial number. Serial number may be required when ordering replacement parts.

Factory Repair

The factory can repair units or lead screws at a fraction of the replacement cost for units that need extensive repair or lead screw replacement. Each unit received will be evaluated and the best repair/replace scenario will be provided to the customer.

Hydraulic Motor Kits

Seal kits are available from your local distributor or the factory. Be prepared to supply unit serial number to determine proper seal kit number.

• RKMM: Includes seals and instructions for replacing worn out or broken seals for all sizes of M-Series motors.
• RKMA: Includes seals and instructions for replacing worn out or broken seals for all sizes of A-Series motors.
• RKMB: Includes seals and instructions for replacing worn out or broken seals for all sizes of B-Series motors.

Reference Additional Maintenance Information